Table of Contents
Advertisement
The following are some instructions during the periodical check:
1). Engine oil check
Check the oil gauge. Make sure there is enough lubricating oil
2.) Fuel tank check
Check for enough fuel in the fuel tank. The fuel tank capacity is 11 L. RQ93 or above unleaded gasoline is recommended. Do not fill too much fuel, or the fuel may overflow and
cause a fire.
3.) Tire pressure check
Check if the tire pressure is normal. The recommended tire pressure is 98kpa; Check if there are any metal fragments or nails stuck in the tire; if so, remove them immediately.
Check if there is any crack or severe tear on the tire, replace the tire if necessary.
4.) Battery check
The normal voltage should be above 12.8V; Keep the terminals clean and the connections tight.; If the voltage is below the normal condition, remove the battery to recharge
5.) Chassis check
After cleaning the chassis, inspect the body, front and rear suspensions, rocker arm, rear axle and fasteners and check if there is any weld failure, crack or loose connections.
Apply some weight to the front bumper and the rear carrier to check the performance of front and rear shock absorber..
6.)Idling speed adjustment
Idle adjusting screw
Oil level stick
Fig 17
Fig 18
12
Hide quick links:
Advertisement
Table of Contents
