Hitachi 32PD5000 Service Manual page 36

Item COLOR TEMPERATURE ADJUSTMENT -PC
Applicable Model
Preparation
(1) Connect the AVC jig and set CRT COLOR
ANALYZER at the center of the screen panel.
(2) Set AVC jig to "Standard" of PC mode, and input
the full-white raster signal to RGB terminal.
Signal condition
VGA (75)
Video level: 0.7Vp-p
Setup level: 0V
(3) Set the display area to "Full".
(This item must be done after the same
adjustment for VIDEO mode.)
32PD5000/42PD5000 (PW1)
42PD5000, 32PD5000, 37PD5200
Procedure
[Adjustment of Cool mode]
(1) Enter the service adjustment mode, and confirm
that No.12(R), 13(G) and 14(B) are all 255. If the
some data are not, set to 255.
(2) Adjust the color temperature by way that reduces
the one or two data in No.12, 13 or 14.
(Note: At least one of them should be 255 after
adjustment.)
<Specification>
Color Temperature (Cool) for PC
12000K
[Adjustment of Normal, Warm, Black/White mode]
(3) Set the adjusted value of COLOR TEMP. ADJ.
-VIDEO (Normal, Warm, Black/White mode; Adj No.
3, 4, 5, 6, 7, 8) to Adj No. 3, 4, 5, 6, 7, 8.
[at VIDEO]
No.3 data
No.4 data
-
-
No.8 data
<Specification>
Color Temperature (Normal) for PC
9300K
<Specification>
Color Temperature (Warm) for PC
6500K
36
x=0.268 0.005
y=0.283 0.005
[at PC]
No.3 data
No.4 data
-
-
No.8 data
x=0.285 0.005
y=0.293 0.005
x=0.314 0.005
y=0.327 0.005