Orion StarSeeker IV Instruction Manual page 5

a
B
Figure 4. The mount arm attaches to the tripod mounting
platform with three captive bolts. A) Line up the bolts with
the holes in the bottom of the arm base. B) Tighten the three
knobs.
a
B
Figure 5. A) Wrap the strap around a tripod leg and pull tight
before fastening. B) The hand controller bracket installed.
4. Attach hand controller bracket to a tripod leg. If you
attach it above the accessory tray it will not be able to
slide down the leg. See Figure 5.
5. To adjust the height of the tripod legs, loosen the tripod
leg clamp knob located on the side of each leg (Figure
6). Extend the inner portion of each leg to the desired
length. Then tighten the tripod leg clamp knob to secure
each leg in place.
Attaching the Telescope Tube to the Mount Arm
6. Unthread the tube lock knob until the bolt tip is not
protruding into the saddle slot (Figure 7). Slide the
telescope's dovetail bar into the saddle on the mount arm
as shown and secure it by tightening the tube lock knob.
Note that the tube lock knob can be positioned either
5