Preparing The Accessories And The Wireless Controller - Canon HR10 Instruction Manual

O
NCE THE BATTERY PACK IS FULLY CHARGED
1 Disconnect the compact power
adapter from the camcorder.
2 Unplug the power cord from the
power outlet and the compact
power adapter.
T
O REMOVE THE BATTERY PACK
BATT.
Slide down to release the
battery pack, and pull out the battery
pack holding it from the ridge on its
bottom part.
IMPORTANT
• Turn off the camcorder before
connecting or disconnecting the
compact power adapter. After you move
the switch to
allocation data is updated on the disc.
Be sure to wait until the LCD display is
completely off.
• You may hear some noise from the
compact power adapter during use.
This is not a malfunction.
• We recommend charging the battery
pack in temperatures between 10 °C
and 30 °C. Outside the temperature
range of 0 °C to 40 °C, the charging will
not start.
• Do not connect to the camcorder's DC
IN terminal or to the compact power
adapter any electrical equipment that is
not expressly recommended for use
with this camcorder.
• To prevent equipment breakdowns and
excessive heating, do not connect the
supplied compact power adapter to
voltage converters for overseas travels
or special power sources such as those
, important file
on aircraft and ships, DC-AC inverters,
etc.
NOTES
• The CHG (charge) indicator also serves
as a rough estimate of the charge
status.
Continuously on: Battery pack fully
charged.
Flashes approx. twice per second:
Battery pack over 50% charged.
Flashes approx. once per second:
Battery pack less than 50% charged.
• We recommend that you prepare battery
packs to last 2 to 3 times longer than
you think you might need.
Preparing the Accessories and the
Wireless Controller
1
Fasten the grip belt.
Adjust the grip belt so that you can
reach the zoom lever with your index
finger, and the
START/STOP
with your thumb.
button
21