Canon HR10 Instruction Manual page 22

Preparations
2
Attach the supplied shoulder
strap.
Pass the ends through the strap
mount and adjust the length of the
strap.
Using the Wireless Controller
First, insert the supplied lithium button
battery CR2025 into the wireless
controller.
1
Press the tab in the direction of
the arrow and pull out the battery
holder.
2
Place the lithium button battery
with the + side facing up.
3
Insert the battery holder.
22
Point the wireless controller at the
camcorder's remote sensor when
you press the buttons.
NOTES
• The wireless controller may not work
properly when the remote sensor is
situated under strong light sources or
direct sunlight.
• If the wireless controller does not work,
check that [WL.REMOTE] is not set to
[
replace the battery.
When you mount the camcorder on a
tripod
Do not leave the viewfinder
Tab
exposed to direct sunlight
as it may melt (due to
concentration of the light by
the lens). Do not use tripods
with fastening screws
longer than 5.5 mm. Doing
so may damage the camcorder.
OFF ] ( 49). Otherwise,