Preparing The Wireless Controller And Accessories - Canon FS1 Instruction Manual

Preparations
Preparing the Wireless Controller and
Accessories
First, insert the supplied lithium button
battery CR2025 into the wireless
controller.
1
Press the tab in the direction of
the arrow and pull out the battery
holder.
2
Place the lithium button battery
with the + side facing up.
3
Insert the battery holder.
T
O USE THE WIRELESS CONTROLLER
Point the wireless controller at the
camcorder's remote sensor when
you press the buttons.
18
You can rotate the LCD panel 180
degrees to use the wireless controller
from the front of the camcorder.
• The wireless controller may not work
properly when the remote sensor is
situated under strong light sources or
direct sunlight.
• If the wireless controller does not work,
check that [WL.REMOTE] is not set to
[
replace the battery.
Tab
Accessories
Fasten the grip belt.
• Adjust the grip belt so that you can
reach the zoom lever with your index
finger, and the
your thumb.
• You can remove the grip belt and
replace it with the supplied wrist
strap.
NOTES
OFF ] ( 78). Otherwise,
Start/Stop
button with