Table of Contents
Advertisement
Energie consumption indicator
en
[Energie consumption
indicator
This function indicates the total amount of energy
o n i n d i c a t o r
E n e r g i e c o n s u m p t i
consumed by this hob the last time it was used for
cooking.
Once switched off, the energy consumption in kWh is
displayed for 10 seconds.
The picture shows an example with an energy
consumption of
.
kWh.
‚
‹‰
You can find out how to switch this function on in the
section on ~ "Basic settings"
26
tSuitability test of tableware
This function can be used to check the speed and
t o f t a b l e w a r e
S u i t a b i l i t y t e s
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
With the cookware still cold, fill it with approx.
1.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely matches
that of the base of the cookware.
Go to the basic settings and select the
2.
Touch the settings range.
3.
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the hotplate display.
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
‹
not heat up.*
The cookware is taking longer to heat up than expected and the
‚
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To reactivate this function, touch the settings range.
Notes
The flexible cooking zone only counts as a single
■
hotplate; place no more than one item of cookware
on it.
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the sections on
~ "Induction cooking" and ~ "Flex Zone".
setting.
™‚ƒ
will flash on the hotplate
A
Hide quick links:
Advertisement
Table of Contents
