Flex Zone; Advice On Using Cookware; As Two Independent Hotplates; As A Single Hotplate - Bosch PXX675DC1E User Manual

Flex Zone

en
|Flex Zone
You can use the hob as a single hotplate or as two
F l e x Z o n e
independent hotplates, as required.
It consists of four inductors that work independently of
each other. If using the flexible cooking zone, only the
area that is covered by cookware is activated.

Advice on using cookware

To ensure that the cookware is detected and heat is
distributed evenly, correctly centre the cookware:

As a single hotplate

Diameter smaller than or equal to 13 cm
Place the cookware on one of the four posi-
tions that can be seen in the illustration.
Diameter greater than 13 cm
Place the cookware on one of the three
positions that can be seen in the illustration.
If the cookware takes up more than one
hotplate, place it starting on the upper or
lower edge of the flexible cooking zone.

As two independent hotplates

The front and rear hotplates each have two induc-
tors and can be used independently of each other.
Select the required heat setting for each of the
hotplates. Use only one item of cookware on each
hotplate.
Recommendations
14
If the hob has more than one flexible
cooking zone, place the cookware on
top so that it covers only one of the flex-
ible cooking zones.
Otherwise, the hotplates will not be
activated as intended and the cooking
result will not be satisfactory.
As two independent hotplates
The flexible cooking zone is used like two independent
hotplates.
Activating
See section ~ "Operating the appliance"
As a single hotplate
Using the entire cooking zone by connecting both
hotplates.
Linking the two hotplates
Set down the cookware. Select one of the two
1.
hotplates assigned to the flexible cooking zone and
set the heat setting.
Touch the symbol. The display lights up.
è
2.
The heat setting appears in the display for the lower
hotplate.
The flexible cooking zone is activated.
Changing the heat setting
Select one of the two hotplates in the flexible cooking
zone and change the heat setting in the settings range.
Adding a new item of cookware
Set the new item of cookware down on the cooker,
select one of the two hotplates in the flexible cooking
zone and then touch the
of cookware will be detected and the heat setting that
was previously selected will be retained.
If the cookware is moved to the hotplate being
Note:
used or lifted up, the hotplate begins an automatic
search and the heat setting selected previously is
retained.
Disconnecting the two hotplates
Select one of the two hotplates in the flexible cooking
zone and touch the è symbol.
This deactivates the flexible cooking zone. The two
hotplates will now function independently.
Notes
If the hotplate is switched off, and then switched
■
back on again later, the flexible cooking zone is
reset to function as two independent hotplates.
To change the configuration settings for the flexible
■
cooking zone, refer to section ~ "Basic settings".
symbol twice. The new item
è