Panasonic WH-MDF09C3E8 Service Manual page 46

6 Insert firmly the connector of remote control
cable (2) to connector (CON1) in the upper
case circuit board. (Refer to the illustration at
below)
7 Secure the remote control upper case to the
lower case with the tabs provided.
11.4.3.3 Connecting The Remote Control
Cable To Mono Bloc Unit
Be sure to turn off the main power before installing and connecting
the remote control. Otherwise, it will cause the electrical shock.
1. Remove the cabinet front plate.
2. Connect the remote control cable with the provided
connector as shown in below illustration. (Refer wiring
diagram for detail.)
3. Guide the remote control cable through the clamper
and Bushing .
(Refer illustration "How to connect Remote Control to
Provided Connector" for detail.)
4. Reinstall the cabinet front plate after connection
complete.
WARNING
11.4.3.4 Disposal of Mono Bloc Unit
Drain Water
When a Drain elbow
below:
The unit should be placed on a stand which is taller
o
than 50mm.
Cover the 8 holes (ø20mm) with Rubber cap
o
to illustration below)
Use a tray (field supply) when necessary to dispose
o
the Mono bloc unit drain water.
If the unit is used in an area where temperature falls
below 0°C for 2 or 3 consecutive days, it is recommended
not to use the Drain elbow
drain water freezes and the fan will not rotate.
46
is used, please ensure to follow
and Rubber cap , for the
(refer