Power Supply - Sanyo CDP-4100CR Instruction Manual

AC adaptor
Plug one end of the AC adaptor into the
DC 6V socket, then plug the other end
into an AC outlet.
• Use only the supplied AC adaptor
• If the AC adaptor is connected. The
power supply automatically switches
to the AC power source and the in-
stalled batteries are disconnected.
Rechargeable battery
1. Install the rechargeable nickel-cad-
mium battery (SANYO NBP-50A) as
shown below. Observe proper polar-
ity.
2. Connect the AC adaptor. The battery
is fully charged approximately 10
hours after the AC adaptor is
connected.
• Do not charge continuously for 24
hours or more.
5

POWER SUPPLY

C O N TA I N N I C K E L - C A D M I U M
BATTERY. MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
Alkaline batteries
Install two "AA" batteries (not supplied)
as shown below. Observe proper polarity.
Battery recharging or replacement
If the rechargeable battery or alkaline
batteries are weak and discharged,
"
power automatically turns off. If this
occurs, recharge the rechargeable bat-
tery or replace the alkaline batteries.
•
Note:
When you are not going to use the unit for
one month or more, take the batteries out
of the battery compartment.
" blinks on the display, then the
Dispose of all used batteries safety
and in accordance with all applicable
laws.