Mitsubishi Electric MSZ-DM25VA Service Manual page 32

Fixing the indoor coil thermistor
There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center
of the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
© Copyright 2015 MITSUBISHI ELECTRIC CORPORATION
Distributed in Dec. 2015. No. OBH750
Made in Japan
OBH750
Holder shape
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
2. Check the (marked)
mounting position.
New publication, effective Dec. 2015
Specifications are subject to change without notice.
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part, the
lead wire should point down.
About the
same length
3. Mount the
clip-shape part.