Mitsubishi Electric Apricot AL Series Owner's Handbook Manual page 55

OWNER'S HANDBOOK
Inserting a SO-DIMM
Caution
Suspend and Standby modes are not the same as 'off';
make sure the machine is properly switched off.
When using the Power switch in Suspend/Resume mode
(as described in the 'Suspend mode' section of Chapter 4,
Battery and Power Management), you can switch the
computer off by holding the Power switch down for four
seconds.
1. Shut down the computer, and turn it off.
2. Close the lid of the computer.
3. Remove the battery and the AC adapter.
4. Remove the screw securing the memory
compartment lid, and lift the lid off. The
memory compartment is located on the
underside of the computer, as shown in the
following diagram.
6 / 2 U p g r a d i n g
5. Carefully slot the memory module into the vacant
slot in the memory compartment. Push the
module firmly into place to insert properly.
6. Replace the memory compartment cover.
7. Switch the machine back on. The computer
detects the new memory automatically.
8. Check that the memory has been detected by
double-clicking on the System icon in the
Control Panel. The amount of RAM available is
displayed at the bottom of the System Properties
dialogue.