OPERATION OF UNIT
STEPS FOR WORKING ON ENGINE OR UNIT
Turn off engine switch
●
Disconnect the spark plug wire from spark plug
●
Securely place the disconnected spark plug wire safely away from the spark plug and any metal parts. This must
●
always be done or arching may occur between the spark plug wire and other metal parts
Repair or replace the part on the engine or unit
●
Check all parts that were repaired or removed during repair to ensure that they are secure and fit correctly
●
Replace spark plug wire
●
PR EPARING ENGINE FOR STARTING
GAS AND OIL
We recommend using non-ethanol gasoline when ever possible. And NEVER use gasoline with an ethanol content
●
higher than E10, 10% ethanol.
Fresh fuel will help to insure a longer service life for your machine. Please use fresh fuel, purchased within 30
●
days of the date of use.
The unit's engine is shipped WITHOUT OIL
●
OIL RECOMMENDATIONS
Oil is a major factor affe ng performance and service
●
life. Use a quality automo ve detergent oil
Non-detergent oil can shorten the engine's service life
●
and 2-stroke oil can damage the engine
SAE 10W-30 is recommended for general use. See
●
Chart A showing its recommended temperature range
With the auger res ng on a level surface with the
●
engine stopped, p the auger on its carry handle and
remove oil filler cap/dip ck and fill with 10W-30 oil
(See Figure 3)
Check the engine's oil level before each use or every 10 hours if operated con nuously
●
When checking oil level, again p auger on its carry handle and remove ail filler cap/dip
●
clean and reinsert dip
hole. Be sure unit is on a level po
TOLL FREE HELP LINE 1 855 691 5969
k without screwing in to check level. If the level is low fill to the edge of oil filler
on as shown (See Figures 3 and 4). Screw cap in securely
OIL FILLER
CAP/DIPSTICK
OIL FILLER HOLE
FIGURE 3
MODEL Y4007
MINI CULTIVATOR AND DETHATH
CHART A
10W-30
0
20 40 60
80
-10 0 10 20 30 40°C
OIL LEVEL
FIGURE 4
ER
100°F
Wipe dip ck
9