Troubleshooting - Garden Trax Y4007 Instructions Manual

TROUBLE SHOOTING
Here at Garden Trax,we strive to build the most durable and best quality designed products. However, all the hard work
and best designs and all the careful maintenance on your part will never assure you that there will never be a problem.
Even the small repair can be annoying. So we have prepared a troubleshooting guide to help you through most of these
easily fixed repairs. The following guide will help you pinpoint the causes of common problems and identify remedies.
For more complicated repairs or any questions you might have concerning your Garden Trax unit, please feel free to
contact your place of purchase or The Garden Trax warranty and authorized service center. We will always be glad to
answer any questions you have, or help you find suitable assistance. To order parts or inquire about warranty, call, write or
email us at the address found below, under the section ordering repair parts.
PROBLEM
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Engine runs, then quits
Engine revs too high
Tines turn at idle
TOLL FREE HELP LINE 1 855 691 5969
POSSIBLE CAUSE
1. Power switch off
2. Spark plug wire disconnected
3. Out of fuel
4. Spark plug wet, faulty or improperly
gapped
5. Throttle control not held open
6. Fuel line hose not positioned in
bottom of gas tank
1. Dirty air filter
2. Choke partially engaged
3. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
4. Throttle control not held open
1. Clogged gas tank
2. Clogged air filter
3. Carburetor out of adjustment or bad
4. Spark plug wet, faulty or improperly
gapped
1. Gas cap not venting
2. Plugged fuel filter
3. Carburetor out of adjustment or bad
1. Carburetor out of adjustment
1. Idle speed too high
2. Broken clutch spring
MODEL Y4007
MINI CULTIVATOR AND DETHATHER
REMEDY/ACTION
1. Flip switch to ON position
2. Connect spark plug wire to spark plug
3. Refuel
4. Clean, replace or gap spark plug
5. Hold throttle control open when pulling recoil
handle
6. Push fuel line down into fuel in gas tank
1. Clean or replace air filter
2. Turn off choke
3. Call factory
1. Drain old fuel and replace with fresh.
2. Make sure spark wire is securely attached to
spark plug
3. Clean carburetor, use gas stabilizer,
Refuel with fresh gasoline."
4. Prime unit 3 more times, then hold throttle open
when pulling recoil handle
1. Remove and clean gas tank
2. Clean or replace air filter
3. Call factory
4. Clean, replace or gap spark plug
1. Clean or replace gas cap, check vent
2. Clean or replace fuel filter
3. Call factory
1. Call factory
1. Adjust idle speed lower
2. Replace spring
18