Catalogue: MOBILE CALL Function Introduction Delete SMS Number GSM Alarm System Alarm Host Diagram Defense Zone Programming Functions Settings Home Arm Defense Zone Setting Initialization Voice Recording Enter Settings Siren Setting Exit Settings Operation Instructions Factory Reset System Status Coding of Remote Controller Remote Controller Operate Delete Remote Controller Out Arm...
Function Instruction: 7 wired and 99 wireless defense zones; Alarm Panel front schematic diagram: LCD screen with time clock display; Voice prompt for all operations; 3 groups of timely arm and disarm; Can store 6 phone numbers: when alarming, system will make alarm call to these numbers automatically;...
X indicates the new 4-digit password. LCD display: LCD display: Exit Settings Press [*] and [#] buttons, the main unit emits a long beep and exits settings. The [SET] indicator goes out and the system returns to disarm state. Ö...
Delete Remote Controller Change Password The remote controller can’t control the main unit after it’s deleted. 1 Change Operation Password In setup state, use keypad to input [21], then input the remote controller Operation password is the password used to disarm or remote control. number [1-8], and then press [#] to confirm.
of the date, the two digits [DD] of the hour (24-hour system), the two Operating method: [XX]Ö[AA]Ö[BB]Ö[#] digits [EE] of the minute, the two digits [FF] of the second, and finally XX indicates: the address code 36, 37, 38 of the timely disarming enter [#] to confirm.
group to the third group [57] ~ [59] For example: delete the first SMS user number from the system Delete Phone Number Operating method: [57] Ö [#] In setup state, input [51] ~ [56], and then press [#] to confirm the main unit will make a long beep and the [Signal] indicator will flicker once and ...
A indicates: [0] Home arm but not alarm Arm] will alarm when detectors are triggered. [1] Home arm and alarm Disarm: defense zone 1~99 will not alarm when detector triggered For example: set defense zone 11 to be Home arm and alarm (except 24 hours defense zone) Operating method: [61] Ö[11] Ö[1] Ö[#] System setup status: In this status, all defense zones will not alarm...
30 seconds later. Remote Control Dial the number associated to the alarm main unit by phone (mobile phone), and after one ringing cycle, you can hear a voice prompt “Please Disarm enter password”. If the password is right, you will here “Press 1 to arm, It means to stop the alarm when the main unit sounds the alarm or make Press 2 to disarm, Press 3 to Monitor, Press 4 to Intercom”.
previous alarming record; press 8, downturn to check; and press [*#] to Whether it can dial the number for alarm normally. exit checking. Whether it can receive wireless detectors’ signal normally For example: the 51st defense zone; the 7th alarming; alarming time: Whether the back-up battery can work normally.
Components list List 2: Main panel 1 pc, Home Alarm Defense Zone Type Siren Remote controller 2 pcs, Information PIR sensor 1 pc, Zone 1 effective invalid real-time Door alarm Door sensor 1 pc, Zone 2 effective invalid real-time Hall alarm Power adapter 1 pc,...
Page 11
Optional sensors/detectors are packed separately. They include remote controller, outdoor siren, transmitter, wireless PIR, wireless gap sensor, wireless gas detector, wireless smoke detector, panic button, baluster, etc. You can choose according to your specific requirements.