Miele W 3923 WPS Operating Instructions Manual page 14

Before using for the first time
Reminder to remove transport struts
To avoid the risk of damage, the
transport struts must be removed
before the machine is used for the
first time. See "Installation and
connection" for instructions on how
to do this.
^ After removing the transport struts (if
this has not already been done by
your fitter) press the right hand Menu
button under OK.
Running your first programme
Your machine is now ready for the first
programme to be run.
Select programme
^ Turn the programme selector to the
Cottons position.
^ Press the Start/Stop button.
^ At the end of the programme switch
the machine off.
Before you can use the washing
machine, the load sensor has to be
calibrated to zero as you would with
bathroom scales.
Downloaded From WashingMachine-Manual.com Manuals
14
Calibrating the load sensor to zero
^ Switch on the washing machine.
^ Open the drum door.
^ Turn the programme selector to the
15:00
^ Press and hold the Load/Detergent
^ Switch off the washing machine.
The machine is now ready for use.
Cottons position.
button pressed in until the following
message appears in the display:
: Zero setting
OK