Fault Messages In The Display - Miele W 3923 WPS Operating Instructions Manual

Problem solving guide

Fault messages in the display

Problem
Fault
2
Check drainage
system
Fault
2
Water intake
Open stopcock
Waterproof system
L
activated
Close the stopcock
Technical fault.
;
Call the Service
Department
The following flashes in
the display:
Anti-crease
alternately with
Check detergent
A To switch off the fault message: Switch the machine off with the I-On/0-Off
button.
Downloaded From WashingMachine-Manual.com Manuals
42
Possible cause
– The water outlet is
blocked or
restricted.
– The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The water protection
system has reacted.
There is a fault.
Excessive foam has
built up during
washing.
Remedy A
– Clean the drain filter and
the drain pump.
– The maximum delivery
head is 1 m.
Check whether
– the stopcock is opened
properly.
– the inlet hose is kinked.
Call the Service
Department.
Start the programme again.
If the fault message
appears again, contact the
Service Department.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.