Antenna; Stand; Camera Unit Installation; Battery And A/C Adapter - Lil' Jumbl Wireless Baby Monitor User Manual

Table of Contents

Advertisement

3.1.2 Antenna

You can adjust the antenna length by sliding the shifter
at the back of the monitor unit. (Pic.2) To achieve optimal
signal reception, you should maximize the antenna length
during operation.

3.1.3 Stand

To place the monitor unit on the table at a viewable angle, you can
flip out the stand at the back side of the monitor unit. (Pic.2)

3.2 Camera Unit Installation

3.2.1 Battery and A/C Adapter

The camera unit can be powered by either the Lithium rechargeable
battery or the A/C adapter. The battery will charge once A/C adapter
is connected.
1. To insert the battery, open the battery door at the right side of
the camera unit, as shown in Pic.3.
2. Insert the battery noting the location of metal pins as
indicated in Pic.3 to assure correct direction.
3. Push the battery inside the bay until it locks.
4. Plug the A/C adapter into the wall outlet then
attach the cord to the "DC IN" jack on the monitor
unit. Feed cord through cord slot. Close battery door.
5. LED power indication:
GREEN: Power on – battery not charging
ORANGE: Power on – battery charging
RED: Power off – battery charging
NO LIGHT: Power off – battery not charging
FLASHING: Low Battery Warning

3.2.2 Wall Mount

The wall mount can provide pan-viewing angles at +/- 30 degrees when the camera unit is placed
on a wall. Place two screws horizontally on the wall at a distance of 2.1" inches apart to mount
the camera unit.
Note: The monitor and camera unit in this package was paired in the factory
settings. You should get image and sound when both units are powered on.
If not, please follow the steps at 4.13 to re-pair both units or check the
troubleshooting section for potential problems.

3.2.3 Temperature Sensor

There is a temperature sensor located at the battery compartment
of camera unit. To receive the accurate data, extend the sensor out
from the battery bay and keep it in a well-ventilated area. (Pic.4)
Battery
Metal Pin
ctory
on.
Temperature Sensor
ature Sensor
6
Antenna Knob
Pic.2
Stand
Pic.3
A/C Adaptor
Pic.4
Pic.4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents