Lullabies Menu; Troubleshooting And Faq - Lil' Jumbl Wireless Baby Monitor User Manual

4.15 Lullaby Menu
On the camera unit, there are five (5) preset lullabies available. In the Main Menu, press the
LULLABY icon. From here you can select SOUND, DURATION, and CAMERAS. Enable/disable PLAY.
The properties of each setting are shown below.

5. Troubleshooting And FAQ

Q. Screen shows no image / blank.
A. Make sure both the monitor and camera unit are powered on. The green or orange LED on the power
button will light and indicate the system is on.
If the power LED does not light, please check if the A/C adapter is properly installed at both DC IN jack
and wall outlet. (For troubleshooting purposes, please connect the monitor unit and camera unit to the
A/C adapter instead of using the Lithium battery)
If the power LED is lit but there is still no screen, remove the battery and unplug the A/C adapter from
monitor and camera unit, and wait sixty (60) seconds. Then plug in the A/C adapters again and try to
power on the system again.
Q. I can see the opening screen and the status bar, but the screen shows "Out Of Range".
A. The message indicates that the monitor unit cannot communicate with the camera unit.
First check the camera number at the left of status bar. Then make sure the corresponding camera is
powered on. You can select the correct camera number by following the steps mentioned at 4.13.1.
If the camera number is correct and the camera unit is powered on, try to shorten the distance
between monitor unit and camera unit, and avoid any obstacles between the two units.
Q. How can I get the best signal reception?
A. Our wireless monitoring system is capable to work at a distance of up to 900 feet in an open area.
However, obstacles like walls, and other 2.4GHz devices like WiFi routers, cordless phones, etc. will
sometimes affect the signal transmission. To obtain the best signal reception, fully extend the antenna
of monitor unit. In addition, place your camera unit vertically to further improve the signal reception.
Q. Why do I get a black and white image on screen?
A. This is the night vision image by infrared light. By default, the system will automatically turn on the
night vision function to capture the image in a dimly lit area. You can manually turn this on or off from
the user menu as mentioned in section 4.14 of this manual.
Q. How can I avoid the shrill sound (feedback noise)?
A. Avoid placing the monitor and camera unit too close together. The closer both units are together,
the louder the shrill sound will be.
Adjust the volume level on both the monitor (from 'VOL +' and 'VOL -' key) and camera unit (in the user
menu) until it renders a desirable sound level.
Setting Description
Cameras Select the camera unit to play lullabies
Sound Select the preset song number to be played back
Duration Choose duration to play Lullaby
Play/Pause Play or Stop the lullabies playback
11
Options
1-4
1-5
1 min, 10 min, 30 min, Stay On.
Play, Pause