Honeywell CO70PE User Manual page 4

USE & OPERATION (CONTINUED)
REMOTE CONTROL (CONTINUED)
Note:
The remote control requires AAA (2 x 1.5V) batteries for replacement.
•
• Open the battery compartment at the back of the remote control and insert the batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
• Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
• Do not mix old and new batteries.
• Do not recharge the battery.
• Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
FILLING WITH WATER
It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time without
refilling the tank. This also helps prevent pump failure in case the cooler is running with inadequate water
in the tank.
CAUTION:
Unplug the unit from the electrical power outlet before filling or emptying the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is
connected to a main water supply.
• Locate the male connector at one end of the garden hose. Insert the
garden hose connector into the water inlet valve of the cooler. Screw
and tighten the water inlet valve onto the threaded part of the garden
hose connector, making sure the hose connector is secured to
ensure there will be no leaks. If there is leakage, the hose and the
water inlet valve may not be connected properly. Try to disconnect,
replace and tighten the water inlet valve again.
• When the connection is secured, turn ON the water supply and the
water will flow into the water tank of the cooler.
• The cooler is now set so the water refills automatically when the
water tank is empty, or when the water reaches below a minimum
level.
• When the water tank is full, the water inlet valve will automatically
stop the water supply from overflowing.
WARNING: The maximum water inlet pressure is 0.5 MPa.
EN 3
Water
Inlet Valve
Garden Hose