1. Manuals
  2. Brands
  3. Hubsan Manuals
  4. Toy
  5. H205B
  6. Instruction manual

Hubsan H205B Instruction Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
H205B Spare Part Chart
H203-01
H203-02
Main Frame set
Bearing
H103-C01
H203-08
Undercarriage
Screw set
H203-A05
H203-13
Balance Bar
Battery
H105-A01
H203B-01
Charging/Switch PCB
Alloy Side
H203-21
H203-22
Lower Head Set
Main Rotor
H205-A01
H203-A04
Body
inner shaft gear set
H203-03
H203-04
Swashplate set
Servor
H203-09
H205-A02
Linkage Set
Tail Decorations
H203-A11
H103B-06
Receiver
Transmitter
H203-19
H203-20
Rotor Grip set
Main shaft set
H203-25
H103-A21
Motor
Charger
H103-A22
H103-A19
usb charger
Charging convert PCB
15
INSTRUCTION
MANUAL
CONTENTS
>INTRODUCTION
>SAFETY NOTES
>SAFETY CHECK BEFORE FLYING
>TRANSMITTER SETUP
>INSTRUCTION FOR BATTERY RECHARGING
>FLYING TRAINING
™
No.H205B

Advertisement

Table of Contents
loading

Related Manuals for Hubsan H205B

Summary of Contents for Hubsan H205B

  • Page 1 ™ H205B Spare Part Chart H203-01 H203-02 H203-03 H203-04 INSTRUCTION Main Frame set Bearing Swashplate set Servor MANUAL H103-C01 H203-08 H203-09 H205-A02 Undercarriage Screw set Linkage Set Tail Decorations H203-A05 H203-13 H203-A11 H103B-06 Balance Bar Battery Receiver Transmitter H105-A01 H203B-01...

  • Page 2: Important Notes

    1 INTRODUCTION Thank you for buying HUBSAN products. The helicopter is designed as an easy to use, full featured RC helicopter model capable of all forms of rotary flight. Please read the manual carefully before assembling the model, and follow all precautions and recommendations within the manual.
  • Page 3 4. Notice that the cyclic joystick is spring-loaded, you must maintain a forwards pressure on the cyclic joystick otherwise it will return to its neutral position and your helicopter will stop moving. Tip-if you become confused, releasing your helicopter's controls will bring it to stop. it will not LiPo batteries differ from conventional batteries in that their chemical contents are lose height as the throttle is on a ratchet.

  • Page 4: Safety Check Before Flying

    Throttle joystick until your helicopter reaches approximately shoulder 2.4 PROPER OPERATION height. For the safety purpose, please only use hubsan’s spare parts for replacement. 2.S-L-O-W-L-Y apply collective Rudder control to point the nose of your helicopter in the direction you wish to fly.
  • Page 5 6.3 Hovering and Cyclic Trim 4 TRANSMITTER Because your helicopter’s rotors create a ‘downdraft’ any 4.1 Identification and functional keys attempt to hover at too low an altitude (height) is more difficult than hovering a little higher. This difficulty is TRANSMITTER because the downdraft from your rotors is bounced back off the ground, resulting in turbulent air around the...

  • Page 6: Input Key Function

    Input Key Function Although the helicopter’s trim has been factory set, you will need to fine tune the Identification Function settings so that your helicopter can maintain a better balanced hover Forward and backward movement of the stick makes the helicopter IMPORTANT: KEEP YOUR CONTROL INPUTS VERY S-L-O-W &...

  • Page 7: Li-Po Battery Charging

    6.2 Effect of Control CAUTION: To avoid loss of control: ALWAYS move the controls S-L-O-W-L-Y! Be aware that control inputs will reduce available lift (see ‘Helicopter Principles of Flight’).Be ready to use a little extra Throttle to maintain height during maneuvers. Return the cover Fasten the screw 5 Li-Po Battery Charging...

  • Page 8: Flight Training

    5.3.Please refer to 2.2. Safety Advisory Notice Always partially charge your LiPo battery before storage. LiPo batteries retain a charge over a reasonable period; It is not normally necessary to recharge stored LiPo batteries unless stored for periods longer than 3-6 months. If your LiPo battery has been over-discharged, it will not be possible to recharge it again.

Table of Contents