Table of Contents
Advertisement
Notes
• The TV/VIDEO button selects an input source of the TV from aerial in or line in.
The button does not control this VCR.
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not mix different types of batteries.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold down u, and enter your TV's code number(s) using the number
buttons. Then release u.
Now you can use the u, VOL +/–, PROG +/–, programme number buttons,
? (ten's digit) and TV/VIDEO buttons to control your TV. You can also
use the buttons marked with a dot (•) to control a Sony TV. To control the
VCR, reset TV / VIDEO to VIDEO .
Tip
• If you set your TV's code number correctly while the TV is turned on, the TV turns
off automatically.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
Manufacturer
Code number
Sony
01*
1
,02,03,04,05
Aiwa
32
Akai
68
Blaupunkt
10,21
Brionvega
40
C.G.M
09
Colonad
03
Dual
44
Manufacturer
Code number
Emerson
03,04
Fenner
30,31
Ferguson
52
Gold Star
03,04,17
1
1
Grundig
10*
,11*
Hitachi
24
Hyper
31
Inno-Hit
41
Getting Started
SLV-X837AS 3-858-900-11 (1)
continued
7
Advertisement
Table of Contents
