Canon CanoScan FS2710 Product Manual page 17

7. Open the dust cover.
• Insert your fingertips into the notch on either side of the dust cover and pull it
gently down.
8. Insert the film holder into the scanner.
• Hold the film holder horizontally on edge as shown below, orienting it so that
the orange mark is on the left side. Insert it straight into the scanner until the
orange mark on the guide lines up with the orange mark on the scanner.
• If the film holder is inserted at an angle, the guide position may be altered
and you may not be able to insert it properly.
• Ensure that the film holder is oriented according to the diagram below so
that the guide is correctly inserted. The film holder will not fit correctly into
the slot if the guide is incorrectly oriented.
Viewed from Above
• Film holders can be purchased separately if the supplied one is broken or
damaged. Inquire at the distributor from which you purchased the scanner.
CanoScan FS2710 Film Scanner
Orange Marks
The orange
mark should
be on the left.
Dust Cover
The 'R' should
be correctly
oriented
when viewed
from the left.
17