B
e
o f
e r
installation
Warning
t f I
e h
e r f
z e
r e
compartment
door is lower than
t
e h
f e r
g i r
r e
t a
r o
compartment
door
t f I
e h
e r f
z e
r e
compartment
door is higher than
t
e h
f e r
g i r
r e
t a
r o
compartment
door
10
Feed water pipe installation (Dispenser model only)
▪Automatic ice maker operation needs water pressure of 147~834kPa
(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is
▪If water pressure does not reach the rating 147kPa(1.5kgf/cm
is necessary to purchase a separate pressure pump for normal automatic icing
and cool water feed.
▪Keep the total length of the feed water pipe tube within 8m and be careful that
the tube does not bend. If the tube is 8m or longer it may cause water feed prob-
lems owing to the drain water pressure.
▪Install the feed water pipe tube at a place free from heat.
▪
Door height adjustment
Level the door by inserting flat( - type) driver into the groove of the left height
adjusting screw and rotate it clockwise ( ).
Level the door by inserting flat( - type) driver into the groove of the left height
adjusting screw and rotate it clockwise ( ).
Height
①
Left height
adjustment screw
①
Installation
) or below, it
2
Height
Right height
adjustment screw