Mitsubishi Electric PEH-RP200 Operation Manual page 6

Remote controller-Button
Opening the door.
1 Set Temperature buttons
Down
Up
2 Timer Menu button (Monitor/Set button)
3 Mode button (Return button)
4 Set Time buttons
Back
Ahead
5 Timer On/Off button (Set Day button)
6 Louver button ( Operation button)
To preceding operation number.
7 Ventilation button ( Operation button)
To next operation number.
8 ON/OFF button
9 Fan Speed button
Remote controller-Display
A Day-of-Week
Shows the current day of the week.
Time/Timer Display
Shows the current time, unless the simple or Auto Off timer is set.
If the simple or Auto Off timer is set, shows the time remaining.
B "Sensor" indication
Displayed when the remote controller sensor is used.
C Identifies the current operation
Shows the operating mode, etc.
* Multilanguage display is supported.
D "Centrally Controlled" indicator
Indicates that operation of the remote controller has been prohibited by a main controller.
E "Timer Is Off" indicator
Indicates that the timer is off.
F Temperature Setting
Shows the target temperature.
G Up/Down Air Direction indicator
The indicator shows the direction of the outcoming airflow.
H "One Hour Only" indicator
Displayed if the airflow is set to weak and downward during COOL or DRY mode. (Opera-
tion varies according to model.)
The indicator goes off after one hour, at which time the airflow direction also changes.
I Louver display
Indicates the action of the swing louver. Does not appear if the louver is stationary.
J Room Temperature display
Shows the room temperature.
6
1
2
3
A
TIME SUN MON TUE WED THU FRI SAT
C
TIMER
AFTER
ERROR CODE
D ˚F˚C
E
ONLY1Hr.
F G H I
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK OPERATION
4 5 67
0 Filter button (<Enter> button)
A Test Run button
B Check button (Clear button)
C Airflow Up/Down button
Notes:
• If you press a button for a feature that is not installed at the indoor unit,
the remote controller will display the "Not Available" message.
• If you are using the remote controller to drive multiple indoor units, this
message will appear only if the feature is not present at the parent unit.
• Never expose the remote controller to direct sunlight. Doing so can re-
sult in the erroneous measurement of room temperature.
• Never place any obstacle around the lower right-hand section of the re-
mote controller. Doing so can result in the erroneous measurement of
room temperature.
B
Hr ON
N
AFTER OFF
FUNCTION
˚F˚C O
FILTER
WEEKLY
P
SIMPLE
AUTO OFF
J K L M
K
(Power On indicator)
Indicates that the power is on.
L Ventilation indicator
Appears when the unit is running in Ventilation mode.
M Fan Speed indicator
Shows the selected fan speed.
N "Locked" indicator
Indicates that remote controller buttons have been locked.
O "Clean The Filter" indicator
Comes on when it is time to clean the filter.
P Timer indicators
The indicator comes on if the corresponding timer is set.
Note:
• For purposes of this explanation, all parts of the display are shown as lit.
During actual operation, only the relevant items will be lit.
: http://splitoff.ru/tehn-doc.html
8
9
ON/OFF
0
FILTER
A
CHECK TEST
B
CLEAR
C