To Select A Video Signal For Display At A Monitor Using The Monitor Handle - Nuvo V1360A User Manual

Nuvo Video Display Systems – User Manual

To Select a Video Signal for Display at a Monitor Using the Monitor Handle

NOTE:
This section applies only to systems with the optional video switching.
Video Display Systems with switching capability may be provided with a button at the bottom of
the sterilizable handle adjacent to each monitor. Channel selection is achieved by repeatedly
pressing this button until the desired image is displayed.
NOTE:
The selection button on the handle performs the same function as the selection button at the
optional wall control panel.
NOTE:
This operation should only be performed by a surgeon or other sterile staff member. Operation by
a non-sterile member of staff will contaminate the handle, which should be immediately replaced
with a sterile handle or covered by a sterile disposable cover.
NOTE:
The video channel selected for display is indicated at the wall control panel by one of the four blue
LED indicators associated with that monitor. If fewer than 4 video inputs are provided, or if any
monitor does not have a video source connected to it, the monitor will show a blank image when
the associated channel is selected.
M2Z00167 Page 10