Nuvo Koolspace 110 Assembly & Operation Manual page 9

1
GET HELP
BEFORE INSTALLING AND KEEP CHILDREN CLEAR OF CELLAR CONSTRUCTION AREA.
Get helper to help guide unit, keep light cord clear of edge inside cellar and to prevent tipping of cellar. MAKE
SURE INSULATION STRIP IS IN CORRECT ORIENTATION. Run light cord through Cut-out. Slide unit into the back
opening by angling unit A to allow light cord to clear and straighten to push in B . Screw allen bolts (G) through
bottom fl ange holes. Make sure unit is level!
CHECK
INSULATION
STRIP
A
NOTE: If unit is operated according to specifi cations overfl ows will not occur. Excess
condensation is only caused by extreme conditions. Unit will shut off at 72 °F and will
restart when temperature drops or unit is repluged. (In this case insert 3/8" O.D. hose
to drain hole, cut to appropriate length.)
STEP 5 : COOLING UNIT INSTALLATION
KEEP UNIT LEVEL
LEVEL TO
SHELF
OPENING
CORD MUST
CLEAR OPENING
G
(G) x2 Flange
bolts in
C
cooling unit
box.
Optional (not required)
except as emergency drain.
~ 9 ~
DO NOT!!!
SIDE VIEW
STRAIGHTEN AND
LIFT UNIT LEVEL
AND PULL FROM
B
DO NOT OVER
TIGHTEN
Container
PUSH THROUGH
GET HELPER TO
INSIDE