Installing And Connecting The Appliance - Bosch KAN62V40 Operating And Installation Instructions

Installing and
connecting
the appliance
S Have a technician install and connect
the appliance according to the
enclosed installation instructions.
S After installing the appliance, wait at
least 1 hour until the appliance starts
up. During transportation the oil in the
compressor may have flowed into the
refrigeration system.
S Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning").
S In addition to the statutory national
regulations, observe the connection
conditions of the local power supply
companies.
S Do not remove the transportation
protection devices from the shelves
and storage compartments until the
appliance has been installed.
Downloaded from Fridge-Manual.com Manuals
Electrical connection
Do not use extension cables or
distributors. This appliance must be
connected to a permanently installed
socket.
The plug to secure the appliance must
be freely accessible. Connect
the appliance to a 220-240 V/50 Hz
a.c. via a plug which has been properly
installed. The socket must be fused
with a 10 to 16 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
right hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs
(e. g. Ecoboy: Sava Plug) or to power
inverters which convert the direct
current to 230 V alternating current
(e. g. solar equipment, power supplies
on ships).
Aligning the appliance
To ensure that the appliance functions
correctly, it must be set level with
a spirit level.
If the appliance is not level, water may
flow out of the ice maker, ice cubes
may be irregular or the doors may not
close properly.
S Place the appliance in the designated
location.
S Align front feet with a hexagon
wrench.
S Align front feet with an Allen key.
en
19