Advertisement
Step 6
Installing the Trim Kit Frame
1. Using the Trim Kit Frame (4) as a
template (and with the microwave oven in
position and secured), center the Trim Kit
Frame around the microwave oven, make
sure the vents point downward. See illus-
tration. Mark the four holes on the side
trim.
2. Remove the Trim Kit Frame.
3. Center punch and drill 3/32" dia. pilot
holes per their hole center marks for the
mounting screws.
4. Position the Trim Kit Frame around the
Oven and secure it with 4 screws (C). Use
the smaller Phillips head screwdriver (#1)
to prevent burring the Phillips head.
The vents on the trim kit frame should
point downward.
For Replacement Installation
If this kit is replacing a JX14, JX16 or JX38
kit, the cutout may be too wide for the trim
screws. If the opening is too wide, the
installer should reduce the opening to 24"
wide by installing wood strips or cleats on
each side to accept the mounting screws.
Part No. 245B1790P071 (2)
Pub. No. 31-1168 (2)
Wall
Installation
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Top
Vent
Bottom
Vent
CAUTION: Do not overtighten screws
since it can cause misalignment of top/
side strips.
Screw C
Mark
Mark
Trim Kit Frame
Vents on top and
bottom should point
downward
(N.D. 313) 2/99
Advertisement
