GE PEB2060SMSS - Countertop Microwave Oven Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)

BEFORE YOU BEGIN

❒
Read these instructions completely and carefully.
IMPORTANT –
•
inspector's use.
IMPORTANT –
•
ordinances.
Note to Installer –
•
Consumer.
Note to Consumer –
•
• For easier installation and personal safety, we recommend that two people
install this microwave oven.
WARNING
grounded 3-hole, 120V receptacle as required by the National Electrical Code.

FOR YOUR SAFETY:

WARNING –
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.

TOOLS YOU WILL NEED

❒ Phillips screwdriver
❒ Pencil
❒ Awl or punch
❒ Level
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
Save these instructions for local
Observe all governing codes and
Be sure to leave these instructions with the
Keep these instructions for future reference.
—
This oven must be plugged into a properly
Before beginning the
❒ Drill with " bit or #35
7 ⁄
64
❒ Tape measure
❒ Scissors (optional)
.
Built-In Trim Kits
JX2027 and JX2030
or
Visit our Website at:
• Do not alter or modify any part of this kit or the oven.
• Unplug the microwave oven before attempting installation of this kit.
• Skill level – Installation of this appliance requires basic mechanical and
electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the Warranty.
• This kit is UL listed for installation alone or over any GE/GE Profile
single electric wall oven. Not for use adjacent to (within 2 feet of) any gas
or electric range, cooktop or oven.
• This kit is for use on models: PEB2060DMBB, PEB2060DMWW,
PEB2060DMCC, PEB2060SMSS, JEB1860DMBB, JEB1860DMWW,
JEB1860DMCC and JEB1860SMSS.

PARTS INCLUDED

PART
NOTE: This kit has extra screws to prevent the technician from spending extra
time locating a replacement screw in case they lose one during installation.
1
ge.com
QUANTITY
❒
Trim Frame
❒
Bottom Duct
❒
Side Duct
❒
4 mm x 12 mm
Round-Head Screws (21 required
for installation)
❒
4 mm x 14 mm
Flat-Head Screws (4 required for
installation)
❒
Anti-Tip Brace
❒
Anti-Tip Bracket
❒
Upper Duct
❒
Top Bracket
❒
Bottom Bracket
❒
Templates
1
1
1
23
6
1
1
1
1
1
2