Line In Operation - Sylvania SKCR2706BT-B Instruction Manual

LINE IN OPERATION

This unit provides an auxiliary audio signal input jack for connecting
external audio devices like MP3 players, CD players and listen to them
through the speakers of this unit.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each
end of the cable.
2. Plug one end into the LINE IN Jack on the main unit and the other end
of the cable into the Line-out Jack or Headphone Jack of your external
audio device.
3. Turn on the unit and external audio device.
4. To select auxiliary audio input, tap the SOURCE button to select LINE IN
mode. "LINE IN" icon appears on display.
5. The volume level can now be controlled through the main unit. Operate
all other functions on the auxiliary device as usual.
NOTE:
If you connect this unit to the Line-Out Jack of your external device then
you only need to adjust the volume control of this unit. If you connected
the Headphone Jack of your external device then you may need to
adjust both the volume control of your external device and the volume
control of this unit to find the most desirable volume setting.
RESETTING YOUR CLOCK RADIO
If the system does not respond or exhibits erratic or intermittent operation,
you may have experienced an electrostatic discharge (ESD) or a power
surge that triggered the internal microcontroller to shut down automatically.
If this occurs, simply disconnect the AC Adaptor and remove the system
back-up battery, wait for at least 3 minutes and then setup the unit again
as if you were using it for the very first time.
16