Siemens GS..N.. Instructions For Use Manual page 35

Fault
Displays do not
illuminate.
Warning signal
sounds.
Temperature display
flashes. Fig. 2/2
Appliance is not
cooling, temperature
display and light
are lit.
Possible cause
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
Fault – the freezer
compartment is too
warm!
Frozen food is at risk!
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
Showroom mode is
switched on.
Remedial action
Connect mains plug. Check whether
the power is on, check the fuses.
To switch off the warning signal,
press the temperature selection
button 4.
Note
Frozen food which has started
thawing or which has thawed can be
refrozen if meat and fish were above
+3 °C for not more than one day
or other frozen food for not more
than three days.
If taste, odour and appearance have
not changed, the food can be boiled
or fried and then refrozen.
No longer store the frozen produce
for the max. storage period.
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been rectified,
the temperature display stops
flashing.
Hold down temperature selection
button fig. 2/4 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
en
35