Set Up Speakers; Set Up Easylink (Hdmi-Cec Control) - Philips htd3500 User Manual

AUDIO IN- AUX
1
Using an analog cable, connect the AUX
connectors on your home theater to the
AUDIO OUT connectors on the TV or
other device.

Set up speakers

Set up the speakers manually to experience
customized surround sound.
Before you start
Make the necessary connections described in
the quick start guide, and then switch the TV to
the correct source for your home theater.
1
SETUP on your home theater
Press
remote control.
2
Select [Audio Setup], and then press OK.
3
Change the following settings, and then
press OK.
[Speakers Volume]: Set the volume
•
level of each speaker.
[Speakers Delay]: Set the delay time
•
for speakers which are placed closer to
the seating position in order to obtain
equal audio transmission from all the
speakers.
Set up EasyLink (HDMI-CEC
control)
This home theater supports Philips EasyLink,
which uses the HDMI-CEC (Consumer
Electronics Control) protocol. EasyLink-
compliant devices that are connected through
11 EN
HDMI can be controlled by a single remote
control.
VCR
•
•
Before you start
•
•
Enable EasyLink
1
2
3
4
EasyLink controls
With EasyLink, you can control your home
theater, TV, and other connected HDMI-CEC
compliant devices with a single remote control.
•
•
Note
Depending on the manufacturer, HDMI-CEC is known
by many names. For information on your device, see
the user manual of the device.
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
Connect your home theater to the HDMI-
CEC compliant device through HDMI
connection.
Make the necessary connections described
in the quick start guide, and then switch
the TV to the correct source for your
home theater.
SETUP.
Press
Select [Video Setup], and then press OK.
Select [HDMI Setup] > [EasyLink Setup]
> [EasyLink] > [On].
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
• On your TV, set the audio output to
'Amplifier' (instead of TV speakers).
For details, see the TV user manual.
[One Touch Play] (One-touch play): When
a video disc is in the disc compartment,
press (Play) to wake up the TV from
standby, and then play a disc.
[One Touch Standby] (One-touch
standby): If one-touch standby is enabled,
your home theater can switch to standby