Set Up Speakers; Set Up Easylink (Hdmi-Cec Control) - Philips HTS3538/12 Quick Start Manual

Option 2: Connect audio through analog
audio cables
Basic quality audio
1
Using an analog cable, connect the AUX
connectors on your home theater to the
AUDIO OUT connectors on the TV or other
device.

Set up speakers

Set up the speakers manually to experience
customized surround sound.
Before you start
Make the necessary connections described in the
quick start guide, and then switch the TV to the
correct source for your home theater.
1
Press SETUP on your home theater
remote control.
2
Select [Audio Setup] and then press OK.
3
Press the Navigation buttons and OK to
select and change:
•
[Speakers Volume]: Set the volume level
of each speaker.
•
[Speakers Delay]: Set the delay time for
speakers which are placed closer to the
seating position in order to obtain equal
audio transmission from all the speakers.

Set up EasyLink (HDMI-CEC control)

This home theater supports Philips EasyLink,
which uses the HDMI-CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices that
are connected through HDMI can be controlled
by a single remote control.
EN
8
•
•
Before you start
•
•
VCR
Enable EasyLink
1
2
3
4
EasyLink controls
With EasyLink, you can control your home theater, TV,
and other connected HDMI-CEC compliant devices
with a single remote control.
•
•
•
Note
Depending on the manufacturer, HDMI-CEC is
known by many names. For information on your
device, see the user manual of the device.
Philips does not guarantee 100% interoperability
with all HDMI-CEC devices.
Connect your home theater to the HDMI-CEC
compliant device through HDMI connection.
Make the necessary connections described in
the quick start guide, and then switch the TV
to the correct source for your home theater.
SETUP.
Press
Select [Video Setup] and then press OK.
Select [HDMI Setup] > [EasyLink Setup] >
[EasyLink] > [On].
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
•
On your TV, set the audio output to
'Amplifier' (instead of TV speakers). For
details, see the TV user manual.
[One Touch Play] (One-touch play): When a
video disc is in the disc compartment, press
to wake up the TV from standby, and then play
a disc.
[One Touch Standby] (One-touch standby):
If one-touch standby is enabled, your home
theater can switch to standby with the remote
control of the TV or other HDMI-CEC devices.
Note
To change the EasyLink control settings, press
SETUP, select [Video Setup] > [HDMI Setup] >
[EasyLink Setup].