Platter Setup - Numark TT500 Operating Instructions Manual

PLATTER SETUP

WARNING: Incorrect Platter setup can lead to poor turntable performance, platter instability, or permanent
motor damage.
1. Start by inspecting the bottom of the aluminum platter to check that both locking pins have rubber fittings
on them.
2. Next, rotate the platter spindle so that two holes are aligned parallel with the front of the turntable.
3. Carefully install the platter onto the center spindle and motor assembly making sure that the Numark logo
and the two holes are aligned parallel with the front of the turntable.
4. The two locking pins should drop into the top of the spindle assembly for a stable and secure fit. If they do
not, grasp the center spindle with one hand while rotating the platter with the other until the locking pins drop
into place. If the platter is properly installed, it should not wobble and should rotate smoothly without any
noise.
1. 2.
Locking Pins
ALIGNED
3. 4.
PLATTER SETUP PAGE 8