Only Starting Of; Altimeter - Brauniger AV-PILOT Operating Instructions Manual

Only starting of

Altimeter

GB
8
starts up automatic self-testing of the unit. All the display elements
appear for a brief moment.
After a few seconds the unit is ready to take off with the previous set-
tings from last time.
The lower bar displays the battery status.
The unit is equipped with two altimeters
allows you to switch between them.
Elevation above sea level
The arrow key are used to change the elevation
adjusted to the actual height over sea level. To avoid this adjusting
procedure the unit now can store 5 special heights of most used points.
This can be done at set mode 13. To go to this marked heights please
press key for 3 sec. The speed display now shows H1 with the pre-
selected height. By pressing the arrow keys you can toggle through max
5-stored height. If you don't want any of these heights you can leave the
mode by pressing the
Reference height - can be reset to 0 by extended pressing of the
key. When switching to
conds, followed again by the real time.
The keys are used to change the elevation
repeated pressing of
and
key.
the flight duration appears for 5 se-
(SF=Special function) appears:
. The key
or or may
or . After