Printout Of The Instrument Settings; Memo (Flight Memory) - Brauniger IQ-CLASSIC Operating Instructions Manual

No Date Max Alt1
dd.mm.yy
----------------------------------------------------------------------------------------------------------------
01 26.07.02
02 30.06.02
----------------------------------------------------------------------------------------------------------------
Pilot
Serial number
Time at printout
Free baro memory
hh:mm Scan rate
75:15 15 s
26:05 05 s
05:13 01 s

Printout of the instrument settings

Memo (flight memory)

6
Max Alt2
m m
2456 728
3043 1319
: Roland Popp
: 5799
: 18:29
An overview of all the settings made by the user as well as a
short list of the polar set can be obtained with the following
printout.
Connect the printer and switch it on
Set the vario to memo mode
Press the
Press and hold the Memo/Enter key to start the printout of the
instrument's settings
IQ instruments can save the data for a maximum of 50 flights
in their memory. A flight is only recognised as such when it
lasts at least 3 minutes and there is a difference in altitude of at
least 30 metres.
Press the Memo/Enter key quickly to access memo mode.
The keys can be used to scroll through the saved flights;
the following data is displayed for each flight:
Max. climb (digital as well as analog)
Max. flying speed (TAS or TGS )
Max. altitude A1
Date
The number of the flight is displayed bottom right. A new
flight is always designated no. 1; all the other flight numbers
increase by one. If a barogram recording was made for the
flight being viewed, the target symbol is also displayed.
Pressing A1-A2-SF/Clear A2 will also display:
Max. descent (digital and analog)
Max. altitude A2
Flying time (hh:mm)
Pressing the same key again will display the total gains in
altitude of the flight A3
Max vario Rec time
m/s hh:mm
7.2 01:24
8.4 02:12
28.07.02
key quickly and "List" is displayed
Baro scan Alt3
/s m
05 s 3675
15 s 6288