Care And Cleaning; Beater To Bowl Clearance - KitchenAid KP2671X Series Instructions And Recipes Manual

Bowl, white flat beater and white dough
hook may be washed in an automatic
dishwasher. Or, clean them thoroughly
in hot sudsy water and rinse completely
before drying. Wire whip, burnished
dough hook and burnished flat beater
should be hand washed and dried
immediately. Do not wash wire whip,
burnished dough hook and burnished
flat beater in a dishwasher.
Your mixer is adjusted at the factory so that the flat beater just clears the bottom of
the bowl. If for any reason, the flat beater hits the bottom of the bowl or is too far
away from the bowl, clearance can be corrected as follows:
• Unplug mixer.
• Place bowl lift handle in down
position.
• Turn screw (A) SLIGHTLY clockwise
to raise the bowl, counterclockwise to
lower the bowl.
• Make adjustments with flat beater, so
it just clears surface of bowl.
NOTE: When properly adjusted, the
flat beater will not strike on bottom or
side of bowl. If beater or wire whip is
adjusted too close so that it strikes
bottom of bowl, coating may wear off
beater or wires may wear through on
wire whip.

Care And Cleaning

Beater To Bowl Clearance

NOTE: Always be sure to unplug
mixer before cleaning. Wipe mixer
with a soft, damp cloth. Do not use
household/commercial cleaners. Do not
immerse in water. Wipe off beater shaft
frequently, removing any residue that
may accumulate.
12
A