Cylindrical Anamorphic Lens Installation And Adjustment; Cylindrical Anamorphic Lens Mounting Assembly - Exploded View - video xtreme VX-3000 Installation & Operation Manual

The Cylindrical Anamorphic lens mount kit consists of everything shown in Figure 3-20.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
10 Anamorphic Lens
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-20. Cylindrical Anamorphic Lens Mounting Assembly - Exploded View
Attaching Lens Mounting Assembly to Lens Motor Carriage Plate or Fixed
CineWide Base Plate:
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or Fixed
CineWide Base Plate (item #7). Position the bracket so that the long slot at the bottom
of the lens holder is perpendicular to the corresponding slots on the plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
4. Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch
Adjustment Yoke (item #2); see Figure 3-21. (Use the round, threaded holes on the
yoke.)
VX-3000 Installation/Operation Manual
Downloaded From projector-manual.com Runco Manuals
Lens Adapter Ring and
1
Mounting Screws (3x)
2
Pitch Adjustment Yoke for Lens
3 Height/Y Adjustment
T-Screw and Washer
(2x)
4
Pitch Adjustment
T-Screw and
Washer (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
45
Installation
Cylindrical Anamorphic
Lens Installation and
Adjustment