video xtreme VX-3000 Installation & Operation Manual page 39

12. Gently push the lens assembly in until it is seated flush against the flange and the
guide pin on the lens assembly is fully seated in the hole on the flange.
Guide Pin
13. Secure the lens assembly to the projector
flange with the three Allen screws on the
outer ring of the assembly, using a 3-mm
hex driver.
Caution
14. Install the foam shield around the front of the lens.
15. Replace the front lens bezel.
16. Tighten the Phillips screw on the bottom of the bezel to secure it.
VX-3000 Installation/Operation Manual
Downloaded From projector-manual.com Runco Manuals
Tighten only these three screws. Do not attempt to adjust any of the
screws behind the lens flange. Doing so may cause the lens to
malfunction.
Guide Pin
mates with
this hole
25
Installation