video xtreme VX-3000 Installation & Operation Manual page 71

Picture Memory: For each input, the VX-3000 lets you store picture quality settings as
presets that you can recall at a later time. You can create up to four presets per input and
resolution, to accommodate changing lighting conditions or viewer preferences.
To select a picture memory preset, highlight Picture Memory in the Picture Adjust menu.
Then, press or
you select "Custom 1" or "Custom 2," any changes to picture quality settings are stored in
the selected preset.
Note
Copy Settings: When you select the "Custom 1" or "Custom 2" Picture Memory preset,
you can copy the settings from another preset to the selected preset. This gives you a
convenient starting point for creating a new, custom preset. To do this, select Copy
Settings from the Picture Adjust menu and press
"Custom 2," "ISF Night" or "ISF Day."
Note
Brightness: On your external test pattern source, select a PLUGE pattern. (PLUGE is an
acronym for "Picture Line-Up Generation Equipment.") Figure 4-2 shows a typical PLUGE
pattern.
Below Black
Above Black
Figure 4-2. Typical PLUGE Pattern for Adjusting Brightness
PLUGE patterns vary but generally consist of some combination of black, white and gray
areas against a black background. The example above includes two vertical bars and four
shaded boxes.
VX-3000 Installation/Operation Manual
Downloaded From projector-manual.com Runco Manuals
to select "Custom 1," "Custom 2," "ISF Night" or "ISF Day." When
1. To store changes to the ISF Night or ISF Day Picture Memory
preset, select that Picture Memory in the ISF menu (refer to ISF
on page 69). You must enter a passcode to access the ISF
menu.
2. The Picture Memory selection you make here is not retained
when the projector is powered off, then on again. To specify
which Picture Memory should take effect when the projector is
powered on, select it in the ISF menu.
To copy changes to the ISF Night or ISF Day Picture Memory
preset, select that Picture Memory in the ISF menu (refer to ISF on
page 69). You must enter a passcode to access the ISF
menu.
. Then, choose "Custom 1,"
57
Operation