Installing And Adjusting The Cinewide Anamorphic Lens; Attach Lens Mounting Assembly To Lens Motor Carriage Plate - video xtreme VX-22d Owner's Operating Manual

If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The VX-22d Anamorphic lens mount kit consists of everything shown in Figure 3-16.
Some components shipped with your projector may differ slightly from what is shown in
these instructions. If any items are missing or damaged, please contact your Runco dealer
or Runco Customer Service at (800) 23-RUNCO.
Lens Adapter Ring and
1
Mounting Screws (3x)
10 Anamorphic Lens
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-16. VX-22d Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
Runco VX-22d Owner's Operating Manual
2
Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw (2x)
4
Pitch Adjustment
T-Screw (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate
39
Installation
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate