Team Orion advantage iq605 Instruction Manual page 10

To modify the discharge settings, press the START key so that the discharge current or discharge end
voltage starts to blink. Use the + and - keys to increase or decrease the discharge current (0.1 – 1A)
or the discharge end voltage (0.1V – 25.0V).
NiMH DISCHARGE
1.0A 5.4V
The cycle mode uses the current charge and discharge settings.
 Launching the charge or discharge
Once you are ready to start the charge, discharge or cycling, press and hold the START key for three
seconds.
Battery type Charge current
NiMH 5.0A 8.40V
CHG 000:40 00010
Mode Charge time
CHG = normal charge mode
DSC = discharge mode
While the charger is charging or discharging the battery, by pressing the START key and using the +
and - keys you can modify the actual charge and discharge current. Then, press the START key again.
You can use the + and - keys to change the information displayed on the screen. Please refer to p.12
for information about the various screens available.
Once the charger has determined that the charge or discharge is complete, the charger stops and the
"FULL" or "END" message is displayed.
FULL 5.0A 8.40V
CHG 030:00 03000
10
Battery voltage
Charged capacity
D>C = discharge-charge cycle
C>D = charge-discharge cycle
Note: you can stop the current process
at any time by pressing the STOP key.
Team Orion Advantage IQ605