York YHKMXH009BARR-FX Service Manual page 72

___________________________________________________________________________________
B=8.0-9.0(mm)
d=4.3-5.3(mm)
T=1.0-2.0(mm)
(For your referrence)
2 Wiring method of straight terminal
For connecting line which end is not a ring, its wiring method as follows: loosen wiring screw
ans insert the end of connecting line totally into the terminal block,then tighten the screw and
pull the connecting line slightly to confirm that it is clamped firmly.
3 Crimp connection method of connecting line
After finishing wiring.connecting line must be fastened by wire clamp,which pressed on the
external sheath of the connecting line, as shown in the right figure:
___________________________________________________________________________________
Brazed seam
Ring Terminal
Correct crimp
connection of wire
Terminal block
Crimp connection
clamp
Wiring method of ring terminal
Incorrect crimp
connection of wire
-71-