York YHKMXH009BARR-FX Service Manual page 133

___________________________________________________________________________________
ON/OFF operation
MODE FAN
OPERATION
HIGH
COOL
ROOM TEMP.
CLOCK
Remarks
Avoid pressing "ON/OFF" switch frequently.
Do not press line controller or switches by sharp objects.
The temperature is on the basis of the setting value. The wind temperature may not reach the setting value because of
the outer air conditioner and system protection.
When the wired controller is power on, the screen fully displays it for two seconds. and clock zone "8888"-"888"-"88"-
"8" flicker for 30 seconds. All the switches are invalid at the time.
MODE FAN SWING
TEMP
HEALTH
CLOCK TIME
TIMER SET RECOVERY
CHECK FILTER
RESET
ON/OFF
2
Press ON/OFF switch on line controller directly
The line controller displays the running state in the latest
4
time (timing and swing state may not be displayed).
1. Press "ON/OFF" switch.
5
The air conditioner starts operating, and the light on the
wired controller is on.
3
2.Choose operation mode.
Press "mode"switch to change to
"AUTO"---"FAN ONLY"---"COOL"---"DRY"---"HEAT".
3.Press "TEMP" switch
Change set temperature:press TEMP or TEMP
time, [SET] will display,and set temperature will
increase/reduce
1
4.Press "FAN SPEED" switch
FAN ONLY Operation:
6
Press "FAN SPEED" switch to change to
"HIGH"--"MED"--"LOW"--"HIGH"
In AUTO,COOL,DRY,HEAT Operation:
Press "FAN SPEED" switch to change to
"AUTO"--"HIGH"--"MED"--"LOW"--"AUTO"
5.Press "swing" switch on the line controller to
swing the wind screen.
6.Press "ON/OFF"switch, off.
The light on the line controller is off.
Note
Several seconds after the operation of the line controller,
the setting of the unit will change.
every