Removing And Replacing The Display Unit - NorthStar Explorer 660 Installation And Operation Manual

1-3 Removing and replacing the display unit

If the display unit is bracket mounted then the
display unit can easily be removed and replaced
for security or protection.
Removing the display unit:
1 Turn the Explorer 660 off (see section 2-1)
2 Push the dust cover over the display unit.
3 Hold the display unit and remove the knobs
from the mounting bracket.
4 Unplug each plug from the back of the
display unit by turning the locking collar
anticlockwise and pulling the plug out.
5 Push the attached dust covers over the
exposed ends of the plugs to protect them.
6 Store the display unit in a dry clean place,
such as the optional Northstar carry bag.
Replacing the display unit
1 Remove the dust covers from the plugs. Plug the
plugs into the back of the display unit:
Match the plug color to the socket color.
Insert each plug and turn the locking collar
clockwise.
Nothing will be damaged if a cable is
plugged into the wrong socket by mistake.
2 Hold the display unit in place in the mounting
bracket. Fit the mounting bracket knobs into
the display unit and do up the knobs loosely.
3 Adjust the tilt and rotation of the display for
best viewing, then hand tighten the knobs
on the mounting bracket. Remove the dust
cover.
Northstar Explorer 660 Installation and Operation Manual
Knob
Mounting
bracket
Adjust
tilt, then
tighten
knobs
Adjust
rotation
9