6-1 What comes with this product?
Standard configuration:
Explorer 443d/443df display unit
•
Power cable
•
Mounting bracket (screws included)
•
Warranty registration card
•
This manual
•
Sun cover for display unit
•
Flush mounting kit
•
Dual frequency transom transducer (includes
•
cable kit and screws)
Transom Mount Transducer Installation Manual.
•
6-2 Options and Accessories
Explorer series of chartplotters
•
Through hull dual frequency transducer
•
Through hull speed/temperature transducer
•
Fuel flow kit (single or twin engine)
•
Replacement paddle wheel
•
SmartCraft Gateway*
•
Explorer R310 (see section 6-6 Systems of
•
several instruments)*
6-3 Mounting and removing the display unit
There are two mounting arrangements:
Flush mounting requires a solid panel
•
with access behind for wiring and mounting
screws. After flush mounting, the Explorer
443d/443df cannot be tilted or moved after
installation to reduce any unwanted glare or
reflections. Carefully select the best viewing
position before installation. This would
generally be in a shaded area.
Bracket mounting requires a panel for
•
mounting the bracket. Ensure that the panel
is not likely to deform and is not subject to
excessive vibration. The bracket can be tilted
and rotated and the Explorer 443d/443df can
be removed after each use.
Northstar Explorer 443d/443df Installation and Operation Manual
Display unit
Dual frequency
transom transducer
Please consult your Northstar dealer for more
information.
* Explorer 443df only
Explorer
538 chartplotter
Select a position where the display unit will be:
At least 4" (100 mm) away from the compass.
•
At least 12" (300 mm) away from any radio
•
transmitter.
At least 4 ft. (1.2 m) away from any antenna.
•
Easy to read by the helmsman and crew while
•
underway.
Protected from physical damage during
•
rough sea passages.
Easy to access the 12V DC power source.
•
Convenient to route the transducer cables.
•
Mounting bracket
Screws
Power cable
Fuel fl ow kit
31