Options And Accessories - NorthStar Explorer 660 Installation And Operation Manual

16-2 Options and Accessories

• Through hull dual frequency sonar transducer
• Through hull speed/temperature transducer
• Fuel kit for single or twin petrol/
gasoline engines.
If a fuel kit is installed, wire auto power on
so that the Explorer 660 is on all the time
the engine is on and no fuel consumption is
missed (see section 15-3).
If the NMEA input on the fuel sensor cable
is used, then a Northstar special fuel cable is
required (see section 16-6).
• Replacement paddle wheel
• Northstar's Explorer R310 (see section 16-6).
• C-MAP™ chart cards.
• C-MAP™ user cards (3 V) for storing data. (The
older 5 volt cards are not supported)
• Beepers with built-in drivers or lights. The
Explorer 660 output is switched to ground, 30 V
DC and 200 mA maximum. If the beepers and
lights require more than 200 mA, fit a relay.
• 5 m (16 ft) extension cable for Northstar 133
GPS antenna.
• GPS or DGPS antenna (see section 7).
• Northstar carry bag.
Please consult your Northstar dealer for
more information.
62 Northstar Explorer 660 Installation and Operation Manual
Through hull
speed/temperature
Transducer
Fuel flow kit
Through hull
dual frequency
Transducer