Table of Contents
Advertisement
SECTION FOUR - Service/Maintenance
Page 64
A blank, properly formatted floppy disk always has enough space to store
your backed-up databases (a Zip disk also has enough space). If you
receive the message "Unable to copy data to the removable disk," check if
the disk is write-protected: To change the write-protection status of a
floppy disk, use the tip of a pen to switch the position of the small square
on the outer corner of the disk.
The save and restore function isn't designed to be used for
your tracks, charts, alarm settings, or the trip. This data can't
be saved to either type of disk as described above.
Saving a database
To save the waypoint and route or user preference databases to a disk:
1. Press the STAR key until you reach the SERVICE MENU screen, then
press the DATABASES AND LOG key. The DATABASE FUNCTION
screen appears.
Figure 32: Database function screen
2. Press the SAVE DATABASES key. The SELECT DATABASE TO SAVE
dialog box appears.
NOTE:
961 INSTALLATION MANUAL Revision A
Advertisement
Table of Contents
Troubleshooting
