Makita 4331D Instruction Manual page 11

ASSEMBLY
1
2
1. Screw
2. Hex wrench
Workpiece to be cut
Stainless steel
CAUTION:
• If the tool is operated continuously at low speeds for a
long time, the motor will get overloaded and heated up.
• The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Installing or removing saw blade
CAUTION:
• Always clean out all chips or foreign matter adhering to
the blade and/or blade holder. Failure to do so may
cause insufficient tightening of the blade, resulting in a
serious personal injury.
• Do not touch the blade or the workpiece immediately
after operation; they may be extremely hot and could
burn your skin.
• Always secure the blade firmly. Insufficient tightening of
the blade may cause blade breakage or serious personal
injury.
To install the blade, loosen the screw counterclockwise on
002717
the blade holder with the hex wrench.
Wood
Mild steel
Aluminum
Plastics
Number on adjusting dial
3 - 5
3 - 5
3 - 4
2 - 3
1 - 4
002790
11